Motor Power: 3 Kw
Weight: 220 Kgs
Dimension: 1600X780X2000 mm
Electricity:380V,50Hz,3 Ph
Usage Description:Collecting Rubber Crumbs which buffed off old tread by Buffing Machine
Multifunctional Repair Stand
Power: 0.18 Kw
With advances in state-of-the-art repair materials and repair methods, many of these tyres can be routinely repaired and in most cases can be retreaded when the original tread is worn off. The repair station is where any surface injury is treated using effective material and tools for grinding and patching.
Rubber Extruder Machine
Even in small injuries it is critical that the injury is cleaned and filled. If this is not done, severe rust, separation and steel cable looseness could take tyre out of service. The injury should be inspected, and then cleaned out with a carbide cutter. After cementing the injury, a vulcanizing rubber stem should be applied to “fill” the injury. This would create a permanent repair that maximizes tyre life.
Glue Mixing Tank
Weight:90 Kgs
Motor Power: 1.5 Kw
Dimension: 800x800x1500 mm
Usage Description: Engineered with explosion-proof motor,Cement Mixing Tank stir industrial solvent and rubber materials evenly to guarantee the procedure of cement spraying.
Tread Building Machine
Dimension: 1800x2100x2100 mm
Wheel Chuck:15'',16''-20'',22.5''
In the Pre-cure Tire Retreading System, the Tread Rubber has already been vulcanized with the new tread pattern design. The buffed tire needs a thin layer of cushion gum to be wrapped around its crown area. The Pre-cured Tread Rubber(PTR) is then applied with the building machine. This is called Building Process.
Dimension:1600x1500x2200 mm
Operate the air cylinder and drive the Spreading Arms outwards to spread the Envelope. Then open the Gripper and grip the bead, and then lift the tire up with the cylinder-driven cable wire and guiding pulley. Rotate the lifting arm and lower the tire into the center of the Spreading Arms, and put it into the envelop. Manipulate the Air Cylinder to retrieve the Spreading Arms and release the Spreading Pads off the Envelop. Then lift the tire out of the Spreader.
Monorail System with Tyre Hanger
Dimension: 4000x1600x2100 mm
Description:
The monorail & hooks system increase productivity by reducing chances of casing contamination and allows for faster loading and unloading of tires.This increases your work place safety and productivity.
Curing Chamber
Dimension: 5500x2100x2350 mm
Heating Power:60 Kw
Usage:The Tires are then placed in Curing Chamber and the pre-cured tread becomes adhered to the tyre through a vulcanizing process
